Record Power WG200 Original Instruction Manual page 16

9. Operation
Adjusting the Torque
The torque of the friction drive can be increased if required to cope with
greater application of pressure during sharpening, see Fig 9.16.
Honing the Tool
After sharpening the tool on the stone it can be honed if required to increase
its sharpness.
Before the first use of the honing wheel mineral oil should be applied to
the leather surface, Fig 9.17. The mineral oil is available as part of the
WG250/X Maintenance Kit. If the maintenance kit is not available then an
alternative mineral oil can be used. The oil will stop the honing paste from
soaking deep into the leather.
Do not apply lubricating oil to the honing wheel.
Carefully apply honing paste to the wheel using a clean rag or sponge as
shown in Fig 9.18 until even coverage is achieved.
Place the support arm in the side position as shown in Fig 9.19.
Mark the edge to be honed with a black marker pen as shown in Fig 9.20.
16
Fig 9.16
Fig 9.17
Fig 9.18
Fig 9.19
Fig 9.20