8. Assembly
Assembly of the Optional WG250/N Profiled Leather
Honing Wheel
The profiled honing wheel is supplied with a shaft extension and 2 washers
as shown in Fig 8.5.
Remove the knob that holds the honing wheel to the machine as shown in
Fig 8.6.
Fit the shaft extension as shown in Fig 8.7.
Fit the profiled honing wheel to the shaft as shown in Fig 8.8 with a washer
on either side and re-fit the knob.
Apply mineral oil and honing paste before use.
12
Fig 8.5
Fig 8.6
Fig 8.7
Fig 8.8