Epson PowerLite 61p Product Information page 6

Epson PowerLite 61p/81p Projector
Adjusting the Image Shape
The projector automatically corrects images that are distorted
when the projector is tilted up or down (up to a 15° tilt). The
Keystone window appears on the screen while the projector
makes the correction. If the projected image still isn't
rectangular or has a "keystone" shape, do one or more of the
following:
If your image looks like
projector off to one side of the screen, at an angle. Move it
directly in front of the center of the screen, facing the screen
squarely.
If your image looks like
feature may have been disabled or you may need to manually
adjust the keystone correction value. (Auto Keystone is not
available when you're using ceiling or rear projection.)
Follow the directions below:
To turn on Auto Keystone, press the
the projetor or remote control. Use the
on the remote control (or the arrow buttons on the
projector) to select the
is
Auto Keystone OFF
. Select in the Auto Keystone window that
Enter ON
appears and press
Enter
menu by pressing the
To manually adjust the keystone correction value, press
the or button on the projector to correct the
shape of the image. After correction, your image will be
slightly smaller.
You can also make keystone adjustments using the projector's
Setting menu.
Adjusting the Brightness
The brightness of an image depends on the source you are
projecting and the amount of light in the room. If the image is
too bright or not bright enough, do one of the following:
Change the
Brightness
Select or for the
Low High
the Setting menu. Low brightness mode extends the life of
the lamp and decreases the fan noise.
6 Epson PowerLite 61p/81p Projector
-
or , you've placed the
or , the Auto Keystone
button on
Menu
pointer button
menu, then press
Setting
, highlight this option and press
to save your changes. Exit the
button.
Menu
setting in the Image menu.
option in
Brightness Control
Adjusting the Color Mode
You may want to adjust the color mode to select a setting
that is appropriate for the image you're projecting and the
environment in which you're projecting it.
If you're projecting computer or RGB video images, the default
color mode is
presentations in bright rooms. For other images, the default
color mode is
natural colors.
The following table lists the available color modes.
Color mode
sRGB
Dynamic
Presentation
. If
Enter
Theater
Living Room
Blackboard
To change the color mode, press the
the remote control until you see the mode you want. The
currently selected setting appears in the upper right corner of
the screen. You can also use the projector menu system to select
the Color Mode in the Image menu.
Correcting Computer Images
If you've connected a computer and the image doesn't look
right, or it doesn't fit properly on the screen, press the
button on the remote control. This automatically resets the
projector's tracking, sync, resolution, and position settings. You
must be projecting an image for this button to have any effect.
Additionally, if the
to , the Auto function will not work.
OFF
6/04
, which is appropriate for
Presentation
, which optimizes video images using
Dynamic
Description
Use when projecting computer images
conforming to the sRGB color standard (the
default setting when projecting from a computer
with analog video).
Best for projecting movies with vivid color in
bright rooms.
Use when you're projecting a presentation in a
bright room.
Use when projecting movies in a dark room.
Best for playing video games or watching TV in a
bright room.
Choose this fixed color mode when you need to
project against a green blackboard.
Color Mode
option in the Signal menu is set
Auto Setup
button on
Auto