Positioning The Projector - Epson PowerLite 5600p Product Information

Mode Refresh Rate (Hz)
HDTV480P (ANSI/ 59.94
SMPTE)
HDTV480P 59.94
(ATSC)
HDTV480I (ANSI/ 59.94
SMPTE)
HDTV480I (ANSI/ 59.94
SMPTE)
HDTV480I 59.94
(ATSC)
HDTV720P 59.94
(SMPTE)
HDTV1080I (ANSI/ 59.94
SMPTE)
HDTV1080P (ANSI/ 59.94
SMPTE)
NTSC (SVGA) 60
NTSC (XGA) 60
PAL (SVGA) 50
PAL (XGA) 50
SECAM (SVGA) 50
SECAM (XGA) 50
Computer Video Port Pin Assignments
The Computer 1 analog port is a female video RGB, 15-pin
micro-D-style connector. Here are the pin assignments:
Pin # Computer 1 port (analog)
1 Red video
2 Green video
3 Blue video
4 Monitor (ID bit 2)
5 GND
6 Red video GND
7 Green video GND
8 Blue video GND
9 +5V
10 Synchronous GND
11 Monitor (ID bit 0)
12 SDA
13 Horizontal sync
14 Vertical sync
15 Reserved
EPSON PowerLite 5600p and 7600p Projectors

Positioning the Projector

Resolution
×
720 483
Follow these guidelines to get the best results when projecting:
×
704 480
❏ Place the projector on a sturdy, level surface, between
3.6 and 48 feet from the screen.
×
720 487
❏ Make sure there is plenty of space for ventilation around and
under the projector.
×
1920 1080
❏ Make sure the projector is within 6 feet of a grounded
×
704 480 electrical outlet or extension cord and within 5 feet of the
image source.
×
1280 720
❏ Face the projector squarely toward the screen. Otherwise,
your image won't be square.
×
1920 1080
Note: It's easier to position the projector when the screen is
directly in front of the room. If the screen is placed diagonally in a
×
1920 1080
corner, it's much more difficult to aim the projector squarely at
the screen and get a non-distorted image.
×
800 438
×
1024 438
If you place the projector below the level of the screen, you'll
have to tilt it up by extending the feet as shown. Tilting the
×
800 512
projector upward causes the image to lose its square shape, but
×
1024 512
you can correct the distortion by pressing the
×
800 512
button as described on page 8.
×
1024 512
If you place the projector level with the bottom of the screen,
the image will be square and you won't have to adjust it. If
you place the projector higher than the bottom of the screen,
the image will still be square, but you won't be able to fill the
whole screen with the image.
1/01 EPSON PowerLite 5600p and 7600p Projectors - 5
Keystone
ideal
height