Using The Control Panel; Using The Remote Control - Epson PowerLite 5600p Product Information

Light Status Description and action
Flashing The projector is getting too hot. Turn it off and
orange let it cool. Make sure the temperature
surrounding the projector does not exceed
104° F and there is plenty of space around
and under the projector for ventilation. Clean
the air filter if necessary.
Red The projector has overheated and turned off
automatically. Let it cool for a few minutes,
then turn it back on. Make sure there is plenty
of space around and under the projector for
ventilation. Clean or replace the air filter, as
needed. If it continues to overheat, there may
be a problem with the cooling fan or internal
circuits; contact EPSON for help.
Flashing red There is a problem with the cooling fan or
temperature sensor. Turn off the projector and
unplug it. Contact EPSON for help.

Using the Control Panel

Power Computer
Video
A/V mute
Resize
Shift
The following table summarizes the functions on the control
panel.
Button Function
Power Starts or stops projection.
Help Displays the online help menu.
Computer Switches between Computer 1 and Computer 2.
A/V mute Turns off the audio and video. (In the menu system,
you can set whether the screen appears black or blue,
or displays a user logo.)
Resize Resizes non-standard computer video formats so they
appear correctly on screen. Switches the aspect ratio
between 4:3 and 16:9 when video images are being
projected.
Video Switches between standard (composite) video,
S-Video, and component video (BNC).
Menu Displays or hides the menu screen.
Esc Help
Menu Sync
Tracking Tracking
Keystone
Volume
Sync
EPSON PowerLite 5600p and 7600p Projectors
Button Function
Esc Stops the current function. Pressing Esc while viewing
a menu or the online help displays the previous
screen or menu.
+
Sync Synchronizes the computer's graphic signal. Use
Sync – these buttons to adjust a fuzzy-looking image that
contains a lot of fine detail. Allows selection of a menu
or menu options if the menu screen is displayed.
Tracking – Matches the projector's internal clock to computer
+
Tracking graphic signals. Use these buttons to eliminate
vertical stripes or bands from an image that contains a
lot of fine detail. Also changes settings during menu
operations.
Enter Selects a menu option or the next menu/help screen.
Pressing Enter when no menu or help screen is
displayed optimizes the computer image.
Shift Pressing the shift and Keystone buttons at the same
time increases or decreases the sound volume.
– Keystone + Use after tilting the projector (extending its feet) to
square up the image. Corrects up to a ±30° tilt.
– Volume + Adjusts the volume when pressed with the Shift
button.

Using the Remote Control

The remote control uses a line-of-sight infrared signal. It lets
you access the projector's features from anywhere in the
room—up to 32 feet away. (This distance may be shorter if
the remote control batteries are low.) If you have connected
the mouse cable, you can also use the remote control as a
wireless mouse.
The projector may not respond to remote control commands
in these conditions:
❏ The remote control is not turned on (using the switch on its
side)
❏ You are too far away or not within 30
the front or rear sensor or 15
❏ Batteries are weak
❏ Ambient light is too bright
❏ A fluorescent light is shining into the infrared receiver
❏ A strong light source (such as direct sunlight) shines into the
infrared receiver
❏ Other equipment emitting infrared energy is present (such as
a radiant room heater)
1/01 EPSON PowerLite 5600p and 7600p Projectors - 9
°
to the left or right of
°
above or below