Rear Panel
Item
12 VDC
REBOOT EMTA
TEL 1/2 and TEL 2
ETHERNET
CABLE
Installing the Battery
This section provides information on installing batteries into the EMTA. Follow the steps
below:
1. Ensure the power adaptor is unplugged.
2. Remove the battery cover on the rear panel. There are two battery
compartments. You may install a single battery into either compartment.
Please note that the center battery-retention slider must be positioned to allow for
battery insertion. After insertion, the slider should be moved back to the center
(retaining) position.
Illustrations contained in this document are for representation only.
Chapter 1: Advanced Information
Description
Power connector
Reset EMTA
RJ-11 Phone set connector
Ethernet 10/100BaseT RJ-45 connector
F-Connector
7