Epson PowerLite 1915 Quick Setup Manual page 3

Project wirelessly
Follow the steps here to connect the projector wirelessly over an 802.11g,
802.11b, or 802.11a wireless network. Your computer must have a
wireless card or built-in wireless interface, and be running Windows
Vista , Windows XP Professional x64, Windows XP, or Windows 2000, or
®
Mac OS X 10.3 to 10.5.
®
1
To install the LAN module, remove the projector's wireless LAN
module cover.
2
Insert the LAN module into the port and replace the cover.
3
Secure the cover using the screw that came with the LAN module.
4
To configure your projector for your wireless network, do one of the
following:
•
If you're using the optional Quick Wireless Connection USB key,
insert it into the projector's USB1 port, look for the displayed
message, remove the key, and connect it to a USB port on your
computer. Follow the on-screen instructions to install the driver,
then run your presentation. For details, see your User's Guide.
•
If you're not using the key, continue with these steps.
5
Press the Menu button on the remote control, select the Network
menu, and press Enter.
6
Choose Network Configuration and press Enter.
7
Select the Wireless LAN menu and press Enter.
8
Click Quick or Advanced, and enter your network's SSID.
9
If your network assigns addresses automatically turn on DHCP. If not,
turn off DHCP and enter the projector's IP Address, Subnet Mask, and
Gateway Address, as needed.
To enter numbers, use the arrow buttons on the remote control to
highlight a number, then press the Enter button. When you're finished
entering an address, highlight Return, then press Enter.
10
To prevent the SSID and IP address from appearing on the network
standby screen, set the SSID Display and/or IP Address Display
settings to Off.
11
See "Install network software" for additional instructions.
Project over a wired
network
If you need to configure the projector for your network, you can use the
projector's menu system.
1
Press the Menu button on the remote control, select the Network menu,
then press Enter.
2
Choose Network Configuration and press Enter.
3
Select the Wired LAN menu and press Enter.
4
Choose IP Settings and press Enter. You see a screen like the following:
5
Do one of the following:
•
If your network assigns addresses automatically, turn on the DHCP
setting.
•
If your network does not assign addresses automatically, turn off
DHCP and enter the projector's IP Address, Subnet Mask, and
Gateway Address, as needed.
To enter numbers, use the arrow buttons on the remote control to
highlight a number, then press the Enter button. When you're finished
entering an address, highlight Return, then press Enter.
6
To prevent the IP address from appearing on the network standby screen,
set the IP Address Display setting to Off.
7
When you're done making all necessary changes, select Setup complete
and press Enter to save your settings. Then press Enter again to confirm.
8
Press the Menu button to exit the menu system.