Water Flow; Operation - Makita M0401 Instruction Manual

1
2
► 1. Wrench 2. Hex wrench 3. Diamond wheel
To remove the diamond wheel, hold the outer flange
with the wrench and loosen the hex bolt clockwise with
the hex wrench. Then remove the hex bolt, outer flange
and diamond wheel.
► 1. Inner flange 2. Diamond wheel 3. Outer flange
4. Hex bolt
To install the diamond wheel, follow the removal pro-
cedure in reverse. Always install the diamond wheel so
that the arrow on the diamond wheel points in the same
direction as the arrow on the blade case. BE SURE TO
TIGHTEN THE HEX BOLT COUNTERCLOCKWISE
SECURELY.
Hex wrench storage
► 1. Hex wrench
When not in use, store the hex wrench as shown in the
figure to keep it from being lost.

Water flow

3
► 1. Tube holder 2. Vinyl tube
Put the vinyl tube into the tube holder just like screwing
in so that used diamond wheel cannot be obstructed or
interrupted.

OPERATION

1
2 •
•
3
4
Hold the tool firmly. Set the base plate on the workpiece
to be cut without the diamond wheel making any con-
tact. Then turn the tool on and wait until the diamond
wheel attains full speed. Now simply move the tool
forward over the workpiece surface, keeping it flat and
advancing smoothly until the cutting is completed. Keep
your cutting line straight and your speed of advance
1 uniform.
6 ENGLISH
CAUTION:
THIS TOOL SHOULD ONLY BE USED ON
HORIZONTAL SURFACES.
Be sure to move the tool forward in a straight
line and gently. Forcing and exerting excessive
pressure or allowing the diamond wheel to
bend, pinch or twist in the cut can cause over-
heating of the motor and dangerous kickback of
the tool.
1
2