Epson MovieMate 72 Quick Manual page 15

The picture is wider at the top or bottom.
You've tilted MovieMate to raise or lower the image, causing it to become
"keystoned." Use the
problem. If you are unable to correct the distortion, you may need to reduce the
degree of tilt.
Better yet, place MovieMate at a height approximately between the top and
bottom of the screen, keeping it level, and then use the vertical image adjustment
dial to position the image. You won't have to correct for keystone distortion this
way, and you'll get a better-looking image.
The picture is taller on the left or right side.
MovieMate is set at an angle to the screen. Face it squarely toward the screen. Use
the horizontal image adjustment dial to center the image. See page 10.
The remote control doesn't work.
■
Make sure the toggle switch is in the correct position: set to
numeric buttons, or to
■
Make sure you're within 23 feet of MovieMate, and within range of its front
or back sensor (approximately 30° left or right, and 15° above or below).
■
You may need to replace the remote control's batteries. Make sure they're
inserted with the positive (+) and negative (–) ends positioned as shown in the
battery compartment.
■
Some DVDs don't support all of the remote control's functions.
■
If you're using a "universal" remote control, it might not work with
MovieMate. Epson does not support any third-party remote controls.
or buttons on the remote control to correct the
to use the other functions of these buttons.
Func.-
to use the
-123
Solving Problems
15