iLive ISBW240 v2863-01 User Manual

Outdoor Bluetooth Speakers with Removable Stakes
User's Guide for Model ISBW240 v2863-01
Features
• IPX6 waterproof protection
• Bluetooth wireless 5.0: range 33 ft.
• Party Plus Mode
• 360 degree sound
• Built-in microphone
• Solar Panel
• Built-in rechargeable battery: approximately 20 hrs
playtime at 50% volume
• USB-C port for battery recharge
Overview
Using the Stakes
The stakes allow you to stabilize these
speakers on the ground for use outdoors.
1. Remove the stakes from the casing
2. Insert the stakes into the bottom of
3. Insert the stakes into the bottom of
Controls
2
4
1. Mode: Press to change source modes to Bluetooth, Aux
in or FM radio.
2. Volume/Skip+/Prev- : Press to adjust volume level. Press
and hold to previous / next track.
3. Charging/Mode Indicator LED: Light will turn solid
red when charging and will turn off when fully charged.
Flashing red when low battery. Solid blue when in Aux in
mode. Flashing blue in every other mode.
4. : Press and hold to enter into pairing mode manually.
5. Power/Play/Pause: Press and hold to power ON or OFF.
Press to play/pause audio. Press to answer phone calls.
ISBW240BDL-2863-01-IB.idml 1
Scan the QR
code to view an
instructional
video.
the casing as shown below.
the speakers and stick the stake into
the ground.
1
3
5
Includes
• 3.5mm audio cable
• USB-C to USB charging cable
• 2 stakes
Battery Charging
To charge the internal battery, plug the USB charging cable
into the DC Power Input on the speaker and a powered on
computer or USB power adapter (not included) and standard
power outlet. Charging time is approximately 3 hours. Battery
life is approximately 20 hours at 50% volume.
When the battery is low a voice will announce "Low Battery, "
then the unit will automatically power OFF.
While the unit is charging it will display a solid red light. When
the battery is fully charged the light will turn off.
Solar Panel
Note: The solar
panel charges at
a VERY slow rate.
Therefore it is best
as a supplemental
charging method.
Aux In & Micro SD
Aux In
Requires a 3.5mm audio cable (included).
1. Connect a 3.5mm audio cable to the Aux In on the unit
and the audio output on an audio device. The unit will
automatically change to Aux in mode.
2. Use the controls on the connected device to select and
play audio. Be sure the volume on your connected device
is audible when you begin playing.
Micro SD
1. Load a Micro SD memory card into the Micro SD port.
2. The speaker will automatically switch to SD mode.
3. Use the controls on your device to select and play audio
from the connected drive.
Aux In Micro SD
3/09/2021 9:05:52 AM