Telephone Base (Fig. 3); Installation; Connecting The Base (Fig. 4); Installing And Charging The Batteries (Fig. 5) - Motorola M4000 User Manual

Base station (see Fig. 3 in page 5)
#
9
6. Instalation
Connecting the base station (see Fig. 4 in page 5)
Plug the power supply and line cord into the base station.
Plug the power adapter into a 110-230 Vac,50/60Hz mains socket and
the line cord into your telephone line socket.
WARNING:
Use only the provided adaptor, using other power supplies may cause a
hazard or damage the phone.
Install the base unit in a position where the mains adapter plug will reach
an easily accessible mains socket to unplug in case needed. Never try to
lengthen the mains power cable.
NOTE:
The base unit needs power for normal operation, it is not just for charging
the handset batteries.
Installing and charging the batteries (see Fig. 5 in page 5)
Place the two batteries, included with your telephone, inside the battery
compartment making sure the correct polarity is properly aligned.
Place the battery compartment cover in place and slide upwards until
it snaps in closed position.
Place the handset in the base and charge for at least 15 hours before using
your telephone for the st time.
> The handset will make a short sound when it correctly placed in a
telephone base or charging base.
9
Find
Press to page your registered handset(s).
Press and hold to start the registration process.
Meaning

Installation