8143 New Serial Interface Board - Epson Stylus T-1000 User Manual

#8143 New Serial Interface Board

If you are using an optional interface, it may be necessary for you to
alter the communications protocol of the printer or the computer so they
can communicate properly. In most cases, you should use the
information in your optional interface manual or your computer's
manual to match the computer with the interface.
For the #8143 optional interface board, use the DIP switch settings
shown below. These switches are on the interface board, not on the
printer.
#8143
DIP switch settings
Function
DIP sw
Selects baud rate
1 - 1
Selects data length
1-2
Selects baud rate
1-3
Selects baud rate
1 - 4
Selects EVEN ODD parity
1-5
Enables /disables parity check
1 - 6
1-7 Selects baud rate
1-8 Enables/disables #8143 mode
O N
See following table
7 bits
See following table
See following table
EVEN
Enabled
See following table
Enabled
Appendix A-9
O F F
8 bits
O D D
Disabled
Disabled