Electrolux EWF 1287 EMW User Manual page 18

18 www.electrolux.com
2. Wait about 2 minutes until the door
lock indicator
goes off.
3. Open the door.
4. Close the door.
5. Press
appears again on the display.
The delay start continues to operate.
10.12 Opening the door when
the programme operates
While the programme operates, the
appliance door is locked and the display
shows the indicator
CAUTION!
If the temperature and level
of the water in the drum are
too high, you cannot open
the door.
1. Press the button
seconds to deactivate the appliance.
2. Wait for some minutes and then open
carefully the appliance door.
3. Close the appliance door.
4. Set the programme again.
10.13 At the end of the
programme
• The appliance stops automatically.
• The acoustic signal operates (if it is
activated).
• In the display
• The indicator of theStart/Pause goes
off.
• The door lock indicator
• You can open the door.
• Remove the laundry from the
appliance. Make sure that the drum is
empty.
• Close the water tap.
• Press the button On/Off for some
seconds to deactivate the appliance.
• Keep the door ajar, to prevent the
mildew and odours.
The washing programme is
completed, but there is water in the
drum:
• The drum turns regularly to prevent
the creases in the laundry.
stops flashing and
again. The indicator
.
for some
comes on.
goes off.
• The door lock indicator
door stays locked.
• You must drain the water to open the
door.
To drain the water:
1. Press .
The appliance drains the water and
spins.
2. To make the appliance drain only, set
. If necessary, decrease the
spin speed.
3. When the programme is completed
and the door lock indicator
off, you can open the door.
4. Press the button On/Off for some
seconds to deactivate the appliance.
The appliance drains and
spins automatically after
approximately 18 hours
(except for Wool
programme).
10.14 AUTO Stand-by option
The AUTO Stand-by function
automatically deactivates the appliance
to decrease the energy consumption
when:
• You do not use the appliance for 5
minutes before you press
Press the button
appliance again.
• After 5 minutes from the end of the
washing programme
Press the button
appliance again.
The display shows the end of the last
set programme.
Turn the programme knob to set a
new cycle.
If you set a programme or an
option that ends with water
in the drum, the AUTO
Stand-by function doesn't
deactivate the appliance to
remind you to drain the
water.
is on. The
goes
.
to activate the
to activate the