Table of Contents
Advertisement
Parts and functions
【Rear】
* This illustration represents WV-S1112
A
Network connector (RJ45)
SD ERROR/ABF indicator
K
INITIAL SET button (Initializing / NTSC ⇔ PAL switch button)
H
■Terminals (rear)
ANetwork connector (RJ45)
Connect an Ethernet cable (category 5e or better) to the network connector.
IMPORTANT:
Use all 4 pairs (8 pins) of the Ethernet cable.
The maximum cable length is 100 m {328 feet}.
Make sure that the PoE device in use is compliant with IEEE802.3af standard.
When connecting both the 12 V DC power supply and the PoE device for power supply, 12 V
DC will be used for power supply.
When the Ethernet cable is disconnected once, reconnect the cable after around 2 seconds.
When the cable is quickly reconnected, the power may not be supplied from the PoE device.
J
C
Audio input connector
G
MONITOR OUT terminal
(factory shipment: NTSC monitor)
B
1 2 V DC power supply terminal
ACT indicator
15
I
LINK indicator
S1132
F
RS485 terminal
E
EXT I/O terminals
D
Audio output connector
S1112
Advertisement
Table of Contents
