Updating Your Printer Firmware - Epson Stylus Pro 4800 Manual

Installing the New Black Ink Cartridge
1. When draining is complete,
appears on the LCD. Raise the ink lever on the left ink
compartment.
2. When
REMOVE CNVRSION CRTG
conversion cartridges from the slots on the left ink
compartment.
3. When
INSERT INK CRTG
their specified slots.
4. When
LOWER BOTH INK LEVERS
levers on the right and left ink compartments.
5. When
RAISE BOTH INK LEVERS
lever on the right and left ink compartments.
The printer starts charging ink. After a while, ink lever
messages appear on the LCD.
Note:
Because ink charging after black ink conversion consumes a
large quantity of ink, you may need to replace the ink cartridges
soon.
6. When a message appears on the LCD, raise or lower the ink
levers accordingly until
When appears on the LCD, ink charging is
READY
complete.
7. If you have installed 110 ml ink cartridges, close the ink
compartment covers. If you have installed 220 ml ink
cartridges, do not close the ink compartment covers.
Updating the Printer Driver Information
After the replacement operation, update the driver
information using the steps below.
❏ Mac OS X
Open the Epson Printer Utility in your Applications folder.
Select
Stylus Pro 4800
button and make sure the Matte Black
StatusMonitor
cartridge option is shown. If not, click
❏ Windows
Click the tab and make sure that the correct ink
Main
cartridge is displayed. If not, set the information manually
by clicking the tab and then the
Utility
button.
Information
RAISE THE LEFT INK LEVER
appears, remove the
appears, insert the cartridges in
appears, lower the ink
appears, raise the ink
appears on the LCD.
READY
, and click . Click the
OK EPSON
.
Update
Printer and Option

Updating Your Printer Firmware

Before you begin using your printer, you should check for a
newer version of firmware on the Epson support site and
update your printer, if necessary.
Downloading the Firmware
1. Navigate to http://www.support.epson.com in your
browser.
2. Choose your printer.
3. Click
Drivers and Downloads
firmware.
4. Choose the version for Macintosh or Windows and follow
the instructions on the screen, then continue in the
appropriate section below to upgrade the firmware.
Updating with Macintosh
1. Double-click the firmware file to extract it.
2. Open the
Applications
and then open the
3. Highlight
Stylus Pro 4800
the button.
Utility
4. Click the
EPSON LFP Remote Panel
Note:
If the button is grayed out, the LFP Remote Panel is not
installed. See the Printer Guide to install it.
8/05
Epson Stylus Pro 4800
to find the newest
folder, open the
Utilities
.
Printer Setup Utility
in the Printer List, then click
button.
Epson Stylus Pro 4800 - 13
folder