Table of Contents
Advertisement
Operation Procedures
Knowledge of the proper operation of the MX500HE is required to
ensure user safety and efficient performance of the extractor.
SET UP AND OPERATION
1. Electrical Cords:
Two 15m extension cords are supplied with the Nautilus MX500HE. The amperage required by each cord
requires that the two cords be plugged into separate circuits:
• Cord #1 (Left side) Powers vacuum #1, vacuum #2, cooling fan and the optional waste pump if so
equipped.
• Cord #2 (Right side) Powers solution pump and the 1750W heater.
An overloaded circuit will not always trip the circuit breaker immediately, but may not provide sufficient
voltage for proper operation and the breaker may trip eventually.
Plug the two power cords into two outlets from different circuits. Proceed with your set-up procedure.
If a circuit breaker trips or the pump circuit breaker trips during operation, reset the breakers and move the
cord to another outlet as needed.
NOT turn the heater on until after the pump has been primed and solution hose and
tool connected
Cord #1
When operating the MX500HE with the 1750W heater DO
Cord #2
EXTENSION CORD:
#CSRCE1515
15M' – 1.5M2 3-GAUGE
M-F PLUGS
9
Advertisement
Table of Contents
