Nautilus HYDRO-FORCE MX500HE Operating Manual page 26

NAUTILUS MX500HE SWITCH PANEL:
(Shown with optional Pump-Out Switch)
Vacuum #1 – Power from Cord #1.
When the switch is turned to the ON
position power is supplied to the vacuum
motor. (2-Stage Vacuum)
Vacuum #2 – Power from Cord #1.
When the switch is turned to the ON position
power is supplied to the vacuum motor.
(2-Stage Vacuum)
Solution Pump Switch – Power from Cord #2.
When the switch is turned to the ON position
power is supplied to the solution pump motor.
When not using solution (Extracting Only) do not
turn this switch ON.
Cooling Fan – Power from Cord #1.
The cooling fan is not controlled by any
switch.
As soon as Cord #1 is plugged in the
cooling fan will turn on to exhaust air from
the base.
Heater – Power from Cord #2.
When the switch is turned to the ON
position power is supplied to the 1750W
heating element, if so equipped.
OPTIONAL - Waste Pump Switch
Power from Cord #1.
Switch ON unless a hose is connected to the
Pump-out Outlet port.
For pump protection there is a pressure switch
which will turn the waste pump off if the
pressure in the discharge line gets too high, as
it would if the pump was turned on while the
outlet cap was still in place.
26
Do not turn Waste Pump