U-Line H-1713 Manual page 6

NOTE: The wireless push button codes must be
copied to the wireless receiver. The maximum
number of wireless push buttons per wireless
receiver is 15.
NOTE: Individual wireless push button codes
cannot be changed or deleted. All codes must
be deleted to start over with new codes.
PROGRAMMING ADDITIONAL WIRELESS PUSH BUTTON
1. Press #1 on the wireless receiver and hold for three
seconds. The green LED light on the back of the
wireless receiver will start blinking. (See Figure 15)
2. Release #1 on the wireless receiver. Then press the
(+) button on the wireless push button. The green LED
light will stop blinking. (See Figure 16)
Figure 15
PAGE 6 OF 20
PROGRAMMING WIRELESS PUSH BUTTON
LED
Lights
#2 #1
3. Press #2 on the wireless receiver and hold for three
seconds. The red LED light on the back of the wireless
receiver will start blinking. (See Figure 15)
4. Release #2 on the wireless receiver. Then press the (–)
button on the wireless push button. The red LED light
will stop blinking. (See Figure 16)
DELETING WIRELESS PUSH BUTTON
1. Press #1 on the wireless receiver for three seconds.
Release and press #1 again for three seconds. The
code has been deleted. (See Figure 15)
2. Press #2 on the wireless receiver for three seconds.
Release and press #2 again for three seconds. The
code has been deleted. (See Figure 15)
Figure 16
1-800-295-5510
uline.com
0421 IH-1713