Electronic Display - U-Line H-1713 Manual

ELECTRONIC DISPLAY

MOUNTING BRACKET TO WALL
1. Determine where to place the display so it is easily
seen by customers.
2. Mark mounting holes on wall using the display wall
mount bracket as a template. (See Figure 6)
3. Drill holes using 5⁄16" drill bit.
4. Use wall anchors (included) if attaching to surfaces
other than solid wood.
5. Position display wall mount bracket over drilled holes
and fasten with two large Phillips screws.
(See Figure 7)
Figure 6
CONNECTING AC POWER SUPPLY
1. Plug the AC power supply into either of the two
power receptacles located on the back of the
display. (See Figure 8)
2. Choose the appropriate country outlet adapter and
slide it into the AC power supply. (See Figure 9)
Adapter
AC Power Supply
PAGE 4 OF 20
DISPLAY – MOUNTING AND INSTALLATION
Figure 7
AC Power Supply
Figure 8
Country Outlet Adapters
Figure 9
3. Attach 10 ft. power extension cable if necessary.
(See Figure 10)
AC Power Supply
4. Plug the AC power supply into the nearest outlet.
CONNECTING WIRELESS RECEIVER
1. Place the pin connector of the wireless receiver on
the pins located on the back of display.
(See Figure 11)
2. Remove backing from adhesive strips on the wireless
receiver and mount it on the back of the display.
Power Extension Cable
Figure 10
PIN CONNECTOR
Figure 11
0421 IH-1713