Electrolux E776W402BI User Manual page 48

Hide thumbs Also See for E776W402BI:
Table of Contents

Advertisement

48
www.electrolux.com
Problem
The laundry is full of dif‐
ferent colours fluff.
After the check, activate the appliance. The programme continues from the point of
interruption.
If the problem occurs again, contact the Authorised Service Centre.
If the display shows other alarm codes, deactivate and activate the appliance. If the problem
continues, contact the Authorised Service Centre.
16.3 Emergency door opening
In case of power failure or functioning
failure the appliance door remains
locked. The washing programme
continues when the power is restored. If
the door remains locked in case of
failure, it is possible to open it using the
emergency unlock function.
Before opening the door:
CAUTION!
Risk of burns! Make sure
that the water temperature
is not too high and the
laundry is not hot. If
necessary, wait until they
cool down.
CAUTION!
Risk of injury! Make sure
that the drum is not
rotating. If necessary, wait
until the drum stops
rotating.
Make sure that the water
level inside the drum is
not too high. If necessary,
proceed with an
emergency drain (refer to
«Emergency drain» in
«Care and cleaning»
chapter).
Possible solution
The fabrics washed in the previous cycle released fluff of a
different colour:
• The drying phase helps to eliminate some fluff.
• Clean the clothes with a fluff remover.
In case of an excessive amount of fluff in the drum run the
special programme to clean it (refer to "Fluff in the fabrics"
for more details).
To open the door, proceed as follows:
1. Press the On/Off button to switch the
2. Disconnect the mains plug from the
3. Pull twice the emergency unlock
4. Take out the laundry and then close
appliance off.
mains socket.
trigger downward and open the
appliance door. The emergency
unlock trigger is located where
indicated by the following picture.
the appliance door.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents