Step 1; Step 2 - modway EEI-2252 Quick Start Manual

EEI-2252
BENCH

STEP 1:

Please put the Bench Top (1) upside down on a carpeted or padded area.
Remove the plastic covers which pre-install in the end of the Bench Top (1) by using Allen Wrench (C).
Insert 1 piece of Leg (2) into Bench Top (1) as shown.
Insert 2 pieces of Bolt (B) from the pre-drilled holes on the bottom of the Bench Top (1) into each side on the bottom of Leg (2).
Insert 2 pieces of Bolt (A) from the pre-drilled holes on the side rail of the Bench Top (1) into each end of Leg (2) as shown.
Do not fully tighten Bolts (A&B) at this step.
Repeat the same steps for the remaining 1 piece of Leg (2).
Use Allen Wrench (C) to tighten all Bolts (A&B) clockwise until secure.
2
A
C
Ax4 Bx4

STEP 2:

Carefully turn over the assembled bench.
Customer Service 908-368-1025︱www.modwayfurniture.com
2
B
A
1
Cx1
Assembly is completed. The bench is ready to enjoy now!
1
2
2
C
B
1
Hardware & Tool required
Page 2 of 2