modway EEI-2937 Manual

Lounger

Download this manual

EEI–2937

LOUNGER

Thank you for purchasing the MODWAY LOUNGER!

Before you start, here are some helpful advice:

1.We suggest you spend a short time reading through this leaﬂet and then follow the simple step by step

instructions.

2.Owing to the size and weight of the lounger, we recommend that it is assembled by two adults, on a

carpeted or padded area, in the room that it is intended for. Approximate assembly time: 30 minutes.

3.Please do not use any tools other than those provided or recommended in these instructions.

4.Please do not throw away any of the packaging or instructions until you have checked all the components and

hardware and the furniture is fully assembled.

5.Assemble all components loosely until advised to tighten. Depending on use, it may be necessary to tighten the

components from time to time, so please save the tools that have been provided.

6.Please keep all pieces out of reach of small children.

Component:

Customer Service 908-368-1025 www.modwayfurniture.com

︱

Hardware:

Bolt M8x50mm

x 4

Bolt M8x40mm

x 16

Allen Wrench M5

x 1

1. Lounger Frame

2. Legs Wheels

3. Legs

4. Cushion

Page 1 of 3

Need help?

Do you have a question about the EEI-2937 and is the answer not in the manual?

Page 1 EEI–2937 LOUNGER Thank you for purchasing the MODWAY LOUNGER! Before you start, here are some helpful advice: 1.We suggest you spend a short time reading through this leaﬂet and then follow the simple step by step instructions. 2.Owing to the size and weight of the lounger, we recommend that it is assembled by two adults, on a carpeted or padded area, in the room that it is intended for.
Page 2 EEI–2937 LOUNGER STEP 1: Please assemble Legs Wheels (2) ﬁrst and connect it with the Wooden support. Next connect Legs (3) into the Wooden support. Insert Bolt (A) to tighten the Legs each side (Left and Right), tighten using Allen Wrench (C). Hardware &...
Page 3 EEI–2937 LOUNGER STEP 3: Insert assembled Legs Wheels (2) and directly insert the Bolt (B), tighten with Allen Wrench (C). Insert assembled Legs (3) and directly insert the Bolt (B), tighten with Allen Wrench (C). Bx16 Cx1 Hardware & Tool required STEP 4: Carefully position the assembled chair to the desired location.