Table of Contents
Advertisement
3.7 Dump
Before removing the CF card from the recorder, it is necessary to press the Dump key to transfer the
measured data and events from the internal memory of the recorder to the CF card
3.8 Clear
If the internal memory goes down to 25%, the mem icon on the top right changes color from green to red.
Also, when the internal memory reserved for events is down to 25 %, the evnt ( event ) icon on the top
right changes color from green to red. In each case the user should transfer all the measured data from the
recorder to CF card by pressing Dump key as above. However, if the measured data and events are not
significant information, the user may also press Clear key to clear them.
3.9 Operate
Press Operate key to start a job manually. For example: to record the alarm by selecting Log alarm.
There are various jobs that may be assigned, as described in Event, Job of 4.1 Channel.
Config
Details about soft key
are described in 4. Configuration.
3.10 Shutdown
Accidental turning off the power will cause loss of data and will interrupt the operation of the recorder.
Therefore press the Shutdown key to shutdown the system first before turning off the power.
3. 11 Logout
If a user orders the option of FDA 21 CFR part 11 compliance, and selects this type of high security, an
extra Logout key appears next to Config key. It is used to record the logout time of the user. Only after the
previous user logout from the recorder, the next user may log into the recorder.
29
Advertisement
Table of Contents
