Table of Contents
Advertisement
MAINTENANCE
Your vacuum comes equipped with three filters located on the vacuum pod: two Pre-Motor Filters
(one is a filter frame) and one Post-Motor Filter to capture and trap dust and debris.
CLEANING PRE-MOTOR FILTER (ONCE A MONTH)
Regularly rinse and replace the pre-motor filters to maintain your vacuum's suction power.
IMPORTANT: To prevent damage, rinse filters with lukewarm water ONLY. DO NOT use soap. Allow filters
to air-dry for at least 24 hours before replacing them in the vacuum to prevent liquid from being drawn into
electric parts.
Foam
Filter
Filter
Frame
12
s h a r kc l e a n . c o . u k
Filter
Door
1. Slide down filter door release button.
2. Tilt filter door and lift off.
3. Remove filter from pod. Pull off foam filter.
4. Rinse foam filter and filter frame with lukewarm
water ONLY and leave to air-dry for at least
24 hours before reinstalling.
5. Once completely dry, reinsert foam filter on
filter frame.
6. Holding the pull tabs, push the filter back
into the pod.
7. Reinsert bottom of filter door into slots on
pod. Tilt door to close, pressing until it clicks
into place.
MAINTENANCE
CLEANING POST-MOTOR FILTER (ONCE A YEAR)
Rinse and replace the post-motor filter every year to maintain your vacuum's suction power.
IMPORTANT: Rinse Post-Motor Filter with lukewarm water ONLY. DO NOT use soap. Allow to air-dry for at least
24 hours before reinstalling. DO NOT scrub Post-Motor Filter.
Post-Motor
Filter
REPLACING FILTERS
Follow the previous instructions for removing filters. The Foam Filter should be replaced every
2.5 years, and the Post-Motor Filter should be replaced every 3 years, subject to frequency of use.
Replacement Pre-Motor Filter
and Frame
NOTE: To order replacement parts and filters, visit sharkclean.co.uk.
1. Pull up on Post-Motor Filter access tab to
remove.
2. Rinse filter with lukewarm water ONLY and leave
to air-dry at least 24 hours before reinstalling.
3. When dry, reinsert Post-Motor Filter and press
down until it clicks into place.
Note: Battery must be removed before Post-Motor
Filter can be removed.
Replacement Post-Motor filter
s h a r kc l e a n . c o . u k
13
Advertisement
Table of Contents
