Turning On And Off; How To Ride; Tightening The Handlebar Stem - ElectrIQ E-SC02PRO User Manual

TURNING ON/OFF
IMPORTANT: Make sure the scooter is upright and placed on a flat surface before starting.

HOW TO RIDE

1. Place one foot firmly on the deck, keeping your other foot on the ground for balance.
2. Press the accelerator on the right handle and put your other foot on the scooter when it
begins to move. This should all be done at very low speed.
3. Press the accelerator gradually to increase speed. Release the accelerator to gently slow
down, or pull the brake lever for more immediate braking.
4. When the scooter has stopped, remove your feet one by one.

TIGHTENING THE HANDLEBAR STEM

If your scooters steering feels loose and unstable, or the
front wheel is out of alignment, the handlebar stem should
be adjusted following the procedure below:
1. Lock the scooter in its folded position.
2. Use the provided allen key to loosen the bolt on the
clamp as shown.
3. Once the wheel is aligned, use the allen key to tighten
the bolt until it is tight. Do not overtighten.
4. Once tightened the handlebars can be unfolded.
Press and hold the power button below the handlebar, for around
2 seconds to turn on the scooter.
Press and hold the power button again to turn off the scooter.
7