About The Control Panel - GE GE04SNLPDG Owner's Manual

About the Control Panel

Models: GE04SNLPDG, GE06SNHPDG, GE08SNHPDG, GE11SNHPDG,
GE15SNLPDG
Displaying Temperature Setpoint
The control will display the temperature setpoint anytime
a button on the control is pressed. After 30 seconds of
inactivity, the display will go blank. To wake the control
at any time to see the temperature setpoint, press the
ENTER button on the control.
Turning on the Water Heater
There is no power button for these models. Once the
water heater is wired and power is supplied, it will be
on. The display will show the current water temperature
setting. To comply with safety regulations, the controls
are factory preset to 120°F (49°C).
Control Features
1. Display
2. + Select Button
Use these buttons to increase the temperature setting.
Single press changes temperature in 1 degree increments.
Press and hold to change temperature continuously.
6
To Adjust the Temperature
Follow these steps:
1. Press the + or - button on the control panel key pad to
desired temperature.
2. Press ENTER to accept the new setting.
NOTE: To change between °F and °C, press and hold
the ENTER button for 3 seconds.
Important Note:
All controls on the interface of this water heater are
capacitive touch. This means activating the function only
requires light touch on button location. Significant push
force is not required.
3. - Select Button
Use these buttons to decrease the temperature setting.
Single press changes temperature in 1 degree increments.
Press and hold to change temperature continuously.
4. Enter Button
Use this button to confirm temperature setting following
adjustment.
49-6000243 Rev. 0