Cleaning The Print Head - Epson Stylus Color 980 Product Information Manual

EPSON Stylus COLOR 980
3. If you need to replace only the color ink cartridge, press the
E load/eject button again until the print head moves to the
color ink cartridge replacement position.
If the print head moves to the home position instead of the
color ink cartridge replacement position, try holding down
E
the load/eject button for three seconds until the print
head moves to the black ink cartridge replacement
position; then press the
second to move the print head to the color ink cartridge
replacement position.
To avoid damaging the printer, never move the print head
by hand. Don't open the clamp or remove a cartridge
except to replace it with a new one. Once you remove a
cartridge, you can't reuse it, even if it contains ink.
4. Remove the new ink cartridge from its packaging.
5. Remove only the yellow part of the tape seal on top, as
shown below. Don't pull off the blue portion or try to
remove the clear seal underneath the cartridge.
Remove the yellow tape
black cartridge
You must remove the yellow tape from the top of the
cartridge or you will permanently damage it. Do not
remove the clear seal from the bottom of the cartridge; ink
will leak.
6. Pull up the ink cartridge clamp. The cartridge rises up from
its holder.
7. Lift the cartridge out of the printer and dispose of it
carefully.
If ink gets on your hands, wash them thoroughly with
soap and water. If ink gets into your eyes, flush them
immediately with water.
10 - EPSON Stylus COLOR 980
E
load/eject button for half a
color cartridge
8. Lower the new ink cartridge into its holder with the label
facing up and toward the back of the printer.
9. Press down the ink cartridge clamp until it locks in place.
10. Press the E load/eject button. The print head moves to the
color ink cartridge replacement position. If you need to
replace the color ink cartridge, repeat steps 6 through 9.
Then continue with step 11.
11. Press the E load/eject button again and close the printer
cover.
The printer moves the print head and begins charging the ink
delivery system. The P power light flashes and the printer
makes various sounds.
Charging takes about one minute. When it's finished, the P
power light stops flashing and stays on.
Never turn off the printer while the P power light is
flashing, unless the printer hasn't moved or made noise
for more than 5 minutes.

Cleaning the Print Head

If your printed image is unexpectedly light or faint, or dots are
missing from the image, you may need to clean the print head.
This unclogs the nozzles so they can deliver ink properly.
Cleaning the print head uses ink, so clean it only if print
quality declines. You can clean the print head in either of the
following ways:
Using the Head Cleaning utility in your printer software
(when the printer is connected to a local port, not over a
network)
Using the printer's control panel buttons
Always wait until your document has finished printing before
cleaning the print head.
If you use special paper that comes with a cleaning
sheet, don't use the cleaning sheet with your printer; it
may jam inside the printer.
8/00