Vidao 65V41UHD User Manual page 20

TV Setup
IMPORTANT NOTE: If your TV is connected to a Cable or
Satellite set top box DO NOT run the "Channel Auto Scan"
in STEP 3.
STEP 3: Setting Air/Cable and Channel Auto Scan
Note: Your type of television connection will determine if you should complete the
Channel Auto Scan part of this step.
Source Select
TV
AV
Component
HDMI1
HDMI2
HDMI3
HDMI4
Media
Setup Wizard
Air / Cable
Go to next step
Select the antenna type then auto scan
Move Next
Setup Wizard
Next
Analog :
Digital :
RF CH :
Total Found :
Move Select
Use the
type of connection (Antenna or Cable without a set top box).
For Cable/Satellite Connections WITH a set top box:
Press the MENU button on the remote control to exit the Setup
Wizard.
NOTE: You will see the message "PLEASE RUN AUTO SCAN"
on the screen. Ignore this message as this is not necessary
when using a set top box.
Press the INPUT button on the remote control to display the
Input Source screen illustrated to the left.
Use the
set top box was installed. Press ENTER to select the desired
input.
Initial Setup is now complete. You may now begin enjoying your
TV, or make further adjustments to the TV settings which are
Cable
explained in the following pages of this manual.
MENU
Exit
For Antenna & Cable Connections WITHOUT a set top box:
Use the
button to begin the Channel Auto Scan.
Channel Auto Scan may take several minutes to complete.
0
0
Once Channel Auto Scan has ended, Initial Setup is
2
0
complete. You may now begin enjoying your TV, or
make further adjustments to the TV settings which are
MENU
explained in the following pages of this manual.
Exit
Initial Setup Wizard
arrow buttons to select Air or Cable based on your
arrow buttons to highlight the input where the
arrow button to select Go to next step and press the
65V41UHD-19