Table of Contents
Advertisement
- Using the throttle you can control the rotation axis of the drone. Using the directional joystick you can control the flight direction
of the drone.
- The mode available on this model is the mode 2 with the layout of the throttle on left. It is not possible to switch mode on this
model.
- The different calibration buttons help keep the drone stationary. Test this by pressing the accelerator and calibration buttons to
maintain the drone in one place.
- You can choose the percentage of the speed. The higher the value, the faster the reaction will be (e.g. 100% will be more
responsive than 40%).
- The two module buttons are used to activate different modules : photos / shots / basket.
Headless Mode Operation : Straighten the copter (red blades are in front) , long press Headless Mode button 2 seconds to enter
into Headless Mode, the transmitter will start beeping; Long press Headless Mode button 2 seconds to exit, the transmitter will
stop beeping.
Altitude hold
This model is equipped with a barometer. The barometer allows the quadcopter to hold altitude without using the remote.
Starting the copter:
- Connect the battery to the copter.
- Turn on the remote
- Trottle up/down to connect drone to remote
- Arm the quad by moving trottle to left bottom and direction to right bottom
- By holding it down for more than 2 sec. you use the throttle to make height. By holding it down for just one seconde, the copter
- Trottle up and it will fly to approx 1m altitude and maintain hight
- Adjust altitude with throttle up/down
Ending:
- Keep light button (middle right) pressed for 1sec and it will autoland
- Alternatively throttle down and when it is securily landed disarm the quad by moving trottle to left bottom and direction to right
Copyright WLtoys.eu | DroneX BV
1.
Stick mode 1/3 indicator
2.
Throttle trim tips
3.
Yaw trim tips
4.
Percentage of the reaction
5.
Transmitter battery indicator
6.
Stick mode 2/4 indicator
7.
Forwards and backwards trim tips
8.
Crab trim tips
Insert the battery by sliding the cover down. Then insert 6 x AA
batteries as indicated under the cover.
Advertisement
Table of Contents
