Table of Contents
Advertisement
Power-on functions
The button combinations below perform additional functions
to control your printer. Paper must be loaded in the printer for
all these operations.
Cleaning N N N + POWER switch
Cleaning O + Cleaning N N N + POWER switch
Cleaning O + POWER switch
Load/Eject + POWER switch
5-4
Controlling the Printer
Checks the paper length and performs a printer self
test. See "Testing the Printer" in Chapter 1 for more
information.
When connected to a PC, prints a page containing a
hexadecimal representation (hex dump) of the data
sent to the printer for troubleshooting use; see
Chapter 7. Continue holding down Cleaning O and
Cleaning N N N for a few seconds after turning on
the printer. Then send a print job. To exit hex dump
mode, press Load/Eject to clear the paper path.
Then turn off the printer.
Prints a demonstration page of the printer's fonts
and colors. Continue holding down the Cleaning O
button for a few seconds after turning on the printer.
To exit demonstration mode, wait until the printer is
done printing, and then turn it off.
Enters the printer's Default setting mode and prints
an instruction page. Continue holding down the
Load/Eject button for a few seconds after turning
on the printer. To exit Default setting mode, turn off
the printer. See page 5-12 for more information.
Advertisement
Table of Contents
