Panasonic nanoe EH‑NA55 Operating Instructions Manual page 6

WARNING
Disconnect the plug by holding onto it instead of
pulling on the cord.
- Failure to do so may cause the wire in the cord to
break, and may cause burn, electric shock, or fire due
to a short circuit.
Regularly clean the plug to prevent dust from
accumulating.
- Failure to do so may cause fire due to insulation failure
caused by humidity.
Disconnect the plug and wipe with a dry cloth.
Always turn off the power switch and disconnect
the plug from the household outlet after use.
- Failure to do so may cause fire or burn.
Insert the plug into the household outlet directly:
Do not use with an extension cord.
Fully insert the plug.
Always ensure the appliance is operated on an
electric power source matched to the rated voltage
indicated on the appliance.
- Failure to do so may cause fire or electric shock.
When the appliance is used in a bathroom, unplug it
after use since the proximity of water presents a
hazard even when the appliance is switched off.
- Failure to do so may cause an accident or injury.
For additional protection, the installation of a
residual current device (RCD) having a rated
residual operating current not exceeding 30 mA is
advisable in the electrical circuit supplying the
bathroom. Ask your installer for advice.
- Failure to do so may cause an accident or injury.
6
If the supply cord is damaged, it must be replaced
by the manufacturer, its service agent (described in
the warranty), or similarly qualified persons in order
to avoid a hazard.
- Failure to do so may cause an accident or injury.
►In case of an abnormality or malfunction
Immediately stop using and remove the plug if
there is any abnormality or malfunction.
- Failure to do so may cause fire, electric shock, or injury.
<Abnormality or malfunction cases>
• Air is not emitted
• Unit stops sporadically
• Interior becomes red hot and smoke is emitted
- Immediately request inspection or repair at an
authorized service center.
►Maintenance
When you see sparks around the air outlet while
using the hot air setting, stop use and remove the
lint on the air outlet and air inlet.
- Failure to do so may cause burn or fire.
►This appliance
Do not block or insert hair pins or other foreign
objects into the air inlet, air outlet, or nanoe™ outlet .
- Doing so may cause fire, electric shock, or burn.
Do not leave the area with the power switch left on.
- Doing so may cause fire.