Battery Charging & Changing Fuse - Tao Motor Boulder B1 Owner's Manual

BATTERY CHARGING
1. Before charging the battery, set ignition key to the" OFF" position.
2. Remove seat.
3. Attach battery charger clamps to battery terminals.
4. Connect low-voltage battery charger to AC outlet. Use GFI AC Type
outlet if possible for additional electrical safety.
5. Check charging level and if charging is complete every 4 to 8 hours to
prevent dangerous overcharging of battery.
6. When charging complete unplug battery charger from wall outlet.
7. Disconnect battery charger cables from battery terminals.
8. Reinstall seat.
DO NOT charge battery with more than 2 Amp trickle charger.
DO NOT charge the battery any longer than 8 hours.
If you notice battery is swelling or bubbling, disconnect battery charger immediately
DO NOT continue to charge battery or attempt to recharge.
DO NOT jump start this ATV by using a car battery or any other vehicles.
CHANGING FUSE
The fuse box is located behind the body on the rear left of the ATV .
1. Set ignition key to the "OFF" position.
2. Remove the blown fuse, check for any shorts or electrical issues and then
install a new fuse of same amperage as specified. And then install a new fuse of
the specified amperage.
3. Set ignition key to the "ON" position, to check if all the devices are
operating.
4. Reinstall seat.
If a fuse continues to blow, contact your local Tao Motor dealer to check for
electrical repair.
Always use a fuse of the specified rating. Never use any substitute fuses or larger amp fuses than the
original rated fuels. Any improper fuse or substitute fuse can cause electrical damage or fire and will
invalidate your vehicle's warranty.
15
Main Fuse Location
1. Main Fuse (10 Amp)
2. Fuse Holder
3. Spare Fuse