Battery Charging & Changing Fuse - Tao Motor BULL 150 Owner's Manual

BATTERY CHARGING
Before charging the battery, set ignition key to the" OFF" position.
1.
Remove seat.
2.
Attach battery charger clamps to battery terminals.
3.
Connect low-voltage battery charger to AC outlet. Use GFI AC Type outlet if possible for
4.
additional electrical safety.
Check charging level and if charging is complete every 4 to 8 hours to prevent dangerous
5.
overcharging of battery.
When charging complete unplug battery charger from wall outlet.
6.
Disconnect battery charger cables from battery terminals.
7.
Reinstall seat.
8.
DO NOT charge battery with more than 2 Amp trickle charger.
DO NOT charge the battery any longer than 8 hours.
If you notice battery is swelling or bubbling, disconnect battery charger
immediately DO NOT continue to charge battery or attempt to
recharge.
DO NOT jump start this ATV by using a car battery or any other vehicles.
CHANGING FUSE
The fuse box is located under the seat in front of the battery.
1. Set ignition key to the "OFF" position.
2. Remove the blown fuse, check for any shorts or electrical issues and then
install a new fuse of same amperage as specified. And then install a new fuse
of the specified amperage.
3. Set ignition key to the "ON" position, to check if all the devices are
operating.
4. Reinstall seat.
If a fuse continues to blow, contact your local Tao Motor dealer to check for
electrical repair.
Always use a fuse of the specified rating. Never use any substitute fuses or larger amp fuses than the
original rated fuels. Any improper fuse or substitute fuse can cause electrical damage or fire and will
invalidate your vehicle's warranty.
13
Main Fuse Location
(under seat in front of
battery)
1. Main Fuse (10 Amp)
2. Fuse Holder
3. Spare Fuse