Setting Up A Network Port On Windows Nt - Epson Stylus C80WN Setup And Installation Manual

5. Expand the network path, as shown, and
select the Stylus C80 printer icon. (Make
sure the IP address matches the print server's
IP address.)
6. Click , then click
OK
7. Click on the Details tab.
Apply
8. To test the connection, click the
and click
Print Test Page
to print.
9. Click if the test page prints, then click
Yes
to close the Properties window.
OK
If it fails to print, try the following:
I
Make sure that the printer and print server are connected and that both are
turned on.
I
Check WP-Admin to make sure you have a signal (see page 22).
I
Make sure you clicked
Now you're ready to print. For instructions, see Printer Basics.

Setting Up a Network Port on Windows NT

Make sure you have Microsoft TCP/IP Printing installed on your computer before
you begin. Run WP-Admin and note the IP address and server name of your print
server. Then follow these steps to set up a network port:
1. From the Start menu, click
2. Right-click the
again.
OK
General
. Wait for the page
in step 7.
Apply
Settings
EPSON Stylus C80 Series
Installing Software and Configuring the Print Server
tab
> .
Printers
printer icon and then click .
Properties
33