Hyundai Tucson 2020 Owner's Manual page 507

Hide thumbs Also See for Tucson 2020:

Table of Contents

7. Place the jack at the designated

jacking position under the frame

closest to the tyre you are chang-

ing. The jacking positions are

plates welded to the frame with

two notches and two dimples.

Never jack any other position or

part of the vehicle. It may damage

to the side moulding.

8. Insert the jack handle into the jack

and turn it clockwise, raising the

vehicle until the tyre clears the

ground. Make sure the vehicle is

stable on the jack.

9. Loosen the wheel nuts with the

wheel nut wrench and remove

them with your fingers. Remove

the wheel from the studs and lay it

flat on the ground out of the way.

Remove any dirt or debris from

the studs, mounting surfaces, and

10. Install the spare tyre onto the

studs of the hub.

11. Tighten the wheel nuts with your

fingers onto the studs with the

smaller end of the wheel nuts

closest to the wheel.

12. Lower the vehicle to the ground

by turning the jack handle anti-

Chapters

Table of Contents