JVC KD-G111 Service Manual page 8

3.1.4 Removing the side panel
(See Fig.4)
Reference:
Remove the front panel assembly as required.
(1) Remove the screw B and two screws C attaching the side
panel on the left side of the main body.
(2) Remove the side panel from the main body.
3.1.5 Removing the rear bracket
(See Fig.5)
• Remove the bottom cover.
(1) For KD-G111, remove the three screws D, three screws E
and two screws F attaching the rear bracket on the back
side of the main body.
(2) For KD-G117, remove the three screws D, screw E and two
screws F attaching the rear bracket on the back side of the
main body.
(3) Remove the rear bracket.
3.1.6 Removing the main board
(See Figs.5 and 6)
• Remove the front panel assembly, bottom cover and side pan-
el.
Reference:
Remove the front chassis assembly as required.
(1) Remove the three screws D attaching the rear bracket on
the back side of the main body. (See Fig.5.)
(2) Remove the two screws G attaching the main board. (See
Fig.6.)
(3) Disconnect the connector
the main body and take out the main board with the rear
bracket. (See Fig.6.)
Reference:
Remove the rear bracket from the main body as required. (See
"3.1.5 Removing the rear bracket".)
1-8 (No.MA125)
CN501 on the main board from
B
C
Side panel
Fig.4
Rear bracket
E
D
( KD-G111 )
Rear bracket
D
( KD-G117 )
Fig.5
CN501
G
Rear bracket
Fig.6
C
E F
F
D
F E F
D
Main board
G