50-Hour Maintenance - Shindaiwa T310Xs Operator's Manual

50-Hour Maintenance

1. New grease
2. Output shaft collar
1. New grease
2. Drain screw
1. Fuel filter
135-Hour Maintenance
3. Old grease
3. Old grease
4. Cutting attachment
not shown
2. Hooked wire
(more frequently in dusty conditions)
Without cutting attachment installed on gearcase:
Clean the cylinder cover and clean grass and dirt from the cyl-
inder fins.
Remove the cutting attachment, cutting attachment holder and
gear shaft collar. Remove the filler plug from the side of the
gearcase and press new grease into the gearcase until old
grease is pushed out. Use good quality lithium multi grease.
Remove mainshaft and lubricate both ends of the splines.
With cutting attachment installed on gearcase:
Clean the cylinder cover and clean grass and dirt from the cyl-
inder fins.
Remove the filler plug and drain screw from the side of the
gearcase and press new grease into the gearcase until old
grease is pushed out. Use good quality lithium multi grease.
Remove mainshaft and lubricate both ends of the splines.
Fuel Filter Maintenance
Use a hooked wire to extract the fuel filter from inside the fuel
tank. Remove and replace the filter element. Before reinstalling
the filter, inspect the condition of the fuel line. If damage or dete-
rioration are noted, the unit should be removed from service until
you can consult with an authorized servicing dealer.
Make sure you do not pierce the fuel line with the end of
the hooked wire. The line is delicate and can be damaged
easily.
Never operate the unit with a damaged or missing silencer
or spark arrester! Operating with a missing or damaged
spark arrester is a fire hazard and could also damage your
hearing.
Carbon deposits in silencer will cause a drop in engine output
and overheating. Spark arrestor screen must be checked pe-
29
Maintenance
CAUTION
WARNING