Pelgrim IK2064F Manual page 31

ERRORS
Symptom
Error code ER03.
Error code E3.
Error code E2.
Fault code E6.
The fuse in the appliance will
blow if all 4 cooking zones are
used on a high power level.
Zone(s) don't work or don't
heat up sufficiently.
Other fault codes.
Possible cause
The control panel is dirty or
has water on it.
Unsuitable pan used.
Appliance over heated.
The appliance has been
connected incorrectly and/or
the mains voltage is too high.
Appliance is connected to
a 1 phase/16 Amp and not
adjusted to "Lo" by software.
Appliance is connected to
a 1 phase/16 Amp and not
adjusted to "Lo".
Defective generator.
Solution
Clean the control panel.
Use a pan suitable for
induction cooking.
The appliance has been
switched off because of over
heating.
Have your connection
changed.
Set the appliance to "Lo"
(power limiter). Refer to the
installation instructions.
The appliance's inbuilt power
limiter limits the maximum
power that can be used
simultaneously. Refer to the
installation instructions.
Contact the service
department.
EN 15