Unoclean UN18C Operator's & Parts Manual page 5

Carefully read and understand this manual before operating this machine.
This machine must be grounded!
This scrubbing machine shall be grounded while in use to protect the operator from electric
shock.Grounding provides a path of least resistance for electric current. This machine is
equipped with a cord having an equipment-grounding conductor and grounding plug. The plug
must be plugged into an appropriate outlet that is properly installed and grounded in accordance
with all local codes and ordinances. Do not remove the ground pin under any circumstances.
This machine is for use on a nominal 110-volt circuit and
has a grounding plug that resembles the plug illustrated
in figure. Make sure that the machine is connected to
an outlet having the same configuration as the plug. No
adapter should be used with this machine.
This machine is intended for commercial use. It is constructed for use in an indoor environment
and is nor intended for any other use. Use only recommended accessories.
1. Do not operate machine:
– Unless trained and authorized.
– In flammable or explosive areas.
– With a damaged cord or plug
– If not in proper operating condition.
2. Before operating machine:
– Make sure all safety devices are in place and operating properly.
3. When using machine:
– Do not run machine over cord.
– Do not pull cord around
sharp edges or corners.
– Do not handle plug with wet hands.
– Report machine damage or fault
operation immediately.
4. Before leaving or servicing machine:
– Turn off machine.
5. When servicing machine:
– Unplug cord from outlet.
To avoid electrical shock,please replace the power cord immediately if any
damage is being detected. The replacement must be performed only by an
authorized person or by our customer service center.
Flammable materials can cause explosion or fire. Do not use flammable
materials in tanks or pick them up.
UN18C
SAFETY PRECAUTIONS
– In outdoor areas and standing water.
– Do not pull machine by cord or plug.
– Do not unplug by pulling on the cord.
– Do not stretch cord.
– Keep cord away from heated surfaces.
– Use manufacturer supplied or
– Unless you have read and
understood the operator's manual.
– With the use of extension cords.
– Unplug cord from outlet.
approved replacement parts.
OPERATOR MANUAL
5