Exmark NAVIGATOR Setup Instructions

Loose Parts
Note: Use the chart below to verify that all parts have been shipped.
Part # Description
103-1309 Warranty Registration Form
109-0460 Literature Pack
109-4295 Manual, Operator
109-0461 Manual, Parts
103-9143 DVD, Exmark Safety Video
103-2106 Keys
106-7022 Tube, Oil Drain
1-850273 Manual, Engine Operator's
WARNING
POTENTIAL HAZARD
♦
Operating a Navigator tractor without an
approved Exmark front mount attachment
increases the possibility of operator
entanglement in drive wheels or forward tip
over.
WHAT CAN HAPPEN
♦
Entanglement or tip-over could cause serious
injury or death.
HOW TO AVOID THE HAZARD
♦
When operating a Navigator tractor without an
approved Exmark front mount attachment,
observe the following:
Keep feet and clothing away from tires.
Limit operation to minimum required to
install a different front mount attachment.
Minimize speed and use extreme caution.
Only operate on a flat level surface.
Do not operate up or down a trailer ramp.
Avoid sudden acceleration or deceleration.
Uncrate Tractor
1. Remove tractor from the crate.
Servicing the Battery
WARNING: Battery posts, terminals, and related
accessories contain lead compounds, chemicals
known to the State of California to cause cancer and
reproductive harm. Wash hands after handling.
SETUP INSTRUCTIONS
Qty Use
1 Fill out and return to Exmark
1 Contains Deck specific material
1
1 Read and view before operating machine
1
1 Unit ignition
1 Draining engine oil
1 For units with Briggs & Stratton engines
The machine is shipped with a filled lead
acid battery.
1. Remove battery cover from machine.
POTENTIAL HAZARD
♦ Charging the battery may produce explosive
gasses
WHAT CAN HAPPEN
♦ Battery gasses can explode causing serious
injury.
HOW TO AVOID THE HAZARD
♦ Keep sparks, flames, or cigarettes away from
battery.
♦ Ventilate when charging or using battery in an
enclosed space.
♦ Make sure venting path of battery is always
open once battery is filled with acid.
2. Check the voltage of the battery with a digital
voltmeter. Locate the voltage reading of the
battery in the table below and charge the battery
for the recommended time interval to bring the
charge up to a full charge of 12.6 volts or
greater.
IMPORTANT: Make sure the negative battery
cables are disconnected and the battery charger
used for charging the battery has an output of 16
volts and 7 amps or less to avoid damaging the
battery (see chart below for recommended charger
settings).
NAVIGATOR
For Serial Nos. 600,000 and Higher
DANGER
Page 1 of 2
109-4296 Rev. A
®