Related Documentation - Epson LQ-1070 Product Information Manual

Non-recommended Commands
Epson recommends against using the following commands because
some of these commands are not supported in existing printers and
some are duplicates of other commands.
BEL Beeper
BS Backspace
DC1 Select printer
DC3 Deselect printer
CAN Cancel data
ESC # Cancel MSB control
ESC< Unidirectional printing for one line
ESC = Set MSB to O
ESC > Set MSB to l
ESC? Reassign bit-image mode
Select n/60-inch line spacing
ESC A
ESC K Select g-dot, single-density, bit-image printing
ESC L Select g-dot, double-density, bit-image printing
ESC Y Select &dot, double-speed, double-density, bit-image
printing
Select quadruple-density bit-image printing
DEL Delete character
Installation/Support Tips
Most application programs let you specify the type of printer you use
so that the program can take full advantage of the printer's features.
Many of these programs provide an installation or setup section that
presents a list of printer-s.
Choosing from a menu
Because Epson printers share a great many commands, you can use
an application program even if it does not list your printer on its
printer selection menu. Choose from the following list (the printers
are listed in the order of preference):
LQ-570
LQ-500
LQ-2550
LQ-2500
LQ-1500
If none of these printers is listed, select the first one available from
the following list:
EX, FX, LX, RX, MS, Epson printer, Standard printer, Draft printer
To use all the features of your printer, however, it is best to choose a
program with your printer on its menu. If your program does not list
this printer, contact the manufacturer of the software to see if an
update is available.
24-Pin Printers
Information Reference List
Engineering Change Notices
None.
Product Support Bulletins
None.
Technical Information Bulletins
None.

Related Documentation

8/20/91
LQ-570/1070
LQ-570/1070-7