Clearing Paper Jams; Using The Default-Setting Mode - Epson FX-2180 Manual

Epson fx-2180: specifications
Hide thumbs Also See for FX-2180:
Table of Contents

Advertisement

4. Remove the separator from the new ribbon cartridge and
discard it. Then turn the ribbon-tightening knob in the
direction of the arrow to remove any slack in the ribbon.
ribbon tightening knob
5. Hold the ribbon cartridge with the ribbon-tightening knob
up. Fit the cartridge's two front notches (1) over the small
pegs on each side of the printer as shown. Then lay the
cartridge flat so that the rear notches (2) fit over the
corresponding pegs.
6. Gently press down the cartridge until both ends click into
place.
7. Lift the cartridge's ribbon guide (1) and insert it over the
metal pins behind the print head (2). Make sure the ribbon
is not twisted or creased and that it is in place behind the
print head. Then press down the ribbon guide until it clicks
into place.
8. Turn the ribbon-tightening knob in the direction of the
9. Slide the print head from side to side to make sure it moves
separator
10. Replace the printer cover and close the paper guide cover.

Clearing Paper Jams

1. Press the
2. If a single sheet of paper is stuck on the paper guide, remove
3. Remove the printer cover. If continuous paper from the rear
4. If continuous paper is jammed in the printer, tear off the
5. Turn the knob on the right side of the printer away from
6. Replace the paper guide, if necessary, and replace the printer
7. Press the

Using the Default-Setting Mode

The default settings control many printer functions. While
you can often set these functions through your software or
printer driver, you may sometimes need to change a default
ribbon guide
setting from the printer's control panel using the default-
setting mode.
11/98
arrow to remove any slack in the ribbon.
smoothly.
button to turn off the printer.
Operate
it.
slot is jammed, also remove the paper guide.
fresh supply at the perforation nearest the paper entry slot.
you to eject the paper in the printer. Remove any remaining
pieces of paper.
Caution:
Always turn off the printer before you use the knob;
otherwise you may damage the printer or lose the top-
of-form or tear-off position.
cover. Then close the paper guide cover.
button to turn on the printer. Make sure
Operate
the
and
Paper Out
Pause
EPSON FX-2180
lights are off.
EPSON FX-2180
- 13

Advertisement

Table of Contents
loading

Table of Contents