Assembly Instructions; Step 2 - modway EEI-2262 Quick Start Manual

EEI-2262
RIGHT ARM LOVESEAT
Remove the plastic covers which pre-install in the end of the Seat Frame (4) by using Allen Wrench (C).
Please put 1 piece of Right Leg (3) on a carpeted or padded area as shown.
Insert Top Rail (1) and Seat Frame (4) into Right Leg (3) as shown.
Insert 3 pieces of Bolts (B) from the pre-drilled holes on the bottom of the Top Rail (1) and Seat Frame (4) into each side
on the bottom of Right Leg (3).
Insert 2 pieces of Bolts (A) from the pre-drilled holes on the side rail of the Seat Frame (4) into each end of Right Leg (3) as shown.
Do not fully tighten Bolts (A&B) at this step.
Repeat the same steps for left Leg (2).
After checking the leveling for all connections, please use Allen Wrench (C) to tighten all Bolts (A&B) clockwise until secure.

STEP 2:

Carefully place the assembled loveseat frame at your desired position.
Put the Seat Cushions (5) and Back Cushions (6) to assembled loveseat frame as shown.
Customer Service 609-256-9000︱www.modway.com
6
5
Assembly is completed. The loveseat is ready to enjoy now!
6
5
Page 2 of 2