Advertisement
Quick Links
Please read the instructions completely before beginning the installation.
Barosa Collection
Model Number: 2480MC
Flush both supply lines before installation, then shut off both supply lines.
Minimum hole size for the spout and handle trim is 1-1/4" and maximum of 1-1/2"
SPOUT INSTALLATION
Remove fastening nut, metal washer and rubber washer from spout
1
assembly. Insert the lift rod into the fixture.
The measurements shown are for reference only. Products and specifications shown are subject to change without notice.
www.santecfaucet.com | P: 310.542.0063 F: 310.542.5681
Rev 06/2016
Installation Instruction
BAROSA COLLECTION
Single Control Lavatory Set
1/7
Advertisement
Related Manuals for Santec Barosa 2480MC
Summary of Contents for Santec Barosa 2480MC
- Page 1 Rev 06/2016 Installation Instruction BAROSA COLLECTION Single Control Lavatory Set Please read the instructions completely before beginning the installation. Barosa Collection Model Number: 2480MC Flush both supply lines before installation, then shut off both supply lines. Minimum hole size for the spout and handle trim is 1-1/4” and maximum of 1-1/2” SPOUT INSTALLATION Remove fastening nut, metal washer and rubber washer from spout assembly.
- Page 2 Apply a ring of silicone caulking around hole designated for spout. DO NOT USE PLUMBERS’ PUTTY WHICH CAN DAMAGE FINISH. Insert faucet assembly through hole in sink or counter top, being sure to center faucet in hole. Reinstall rubber gaket and metal washer from below. Hand tighten fastening nut from below while aligning fixture.
- Page 3 POP-UP INSTALLATION Remove the decorative drain flange, drain plug and gasket from pop-up assembly. Do not remove the washer and lock nut. Place the flange gasket onto the drain tube beveled side upward and on top of the washer. Apply a ring of silicon caulking around the top of sink drain opening.
-
Page 4: Parts Drawing
PARTS DRAWING PART DESCRIPTION PART # Flexible Hose - Cold K1321 Flexible Hose - Hot K1322 Lift Rod P0234 Rubber Pad P0803 P0804 Lock Nut PM-383 25mm Control Cartridge P0356 Complete Single Control Spout PS-600-U * Please specify the finish when ordering the part. The measurements shown are for reference only. -
Page 5: Specification Sheets
SPECIFICATION SHEETS 8 " 2 " 8 " " " 8 " POP-UP Ø 2 " " " 12" Ø 1 " The measurements shown are for reference only. Products and specifications shown are subject to change without notice. www.santecfaucet.com | P: 310.542.0063 F: 310.542.5681... -
Page 6: To Obtain Warranty Service
Doing so may ruin your faucet finish and/or void the warranty. Thank you for making SANTEC a part of your lifestyle and luxury spa experience. Our products have been created as works of enduring quality and sophisticated design. -
Page 7: Lifetime Limited Warranty
SANTEC reserves the product components of the covered product will be repaired, refinished, or replaced at the sole discretion of SANTEC. SANTEC reserves the right to examine any product claimed defective prior to any warranty claim being accepted or processed, at its sole discretion. This warranty gives you specific legal rights and you may have other rights which may vary from state to state.