AEG 7000 Series User Manual page 35

1
2. Place a suitable bowl below the drain
pump access to collect the water that
flows out.
3. Open the chute downwards. Always
keep a rag nearby to dry up any
water spillages when removing the
filter.
4. Turn the filter 180 degrees in anti-
clockwise direction to open it,
without removing. Let the water flow
out.
5. When the bowl is full of water, turn
the filter back and empty the
container.
6. Repeat the steps 4 and 5 until the
7. Turn the filter anti-clockwise to
2
8. If it is necessary, remove fluff and
9. Make sure that the impeller of the
10. Clean the filter under the water tap.
11. Put the filter back into the special
water stops to flow out.
remove it.
1
objects from the filter recess.
pump can rotate. If it does not
rotate, contact the Authorised
Service Centre.
guides by turning it clockwise. Make
sure that you tighten the filter
correctly to prevent leakages.
ENGLISH 35
2