Advertisement
Operating instructions
Read the EntiRE iMpORtAnt SAFEty inFORMAtiOn section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.
tool Set Up
tO pREVEnt SERiOUS inJURy FROM AcciDEntAL DiScHARGE:
Make sure that the trigger is in the off-position and remove its Battery
pack before performing any procedure in this section.
Battery charging
Charge battery after unpacking and before using this tool. Follow
instructions included with battery charger (sold separately)
Workpiece and Work Area Set Up
1. Designate a work area that is clean and well lit.
The work area must not allow access by children
or pets to prevent distraction and injury.
Single-Sequential Actuation Mechanism Definition
The single-sequential activation mechanism is designed to allow accurate placement of fasteners. Use the
switch next to the LED Indicator to change modes. The tool should only actuate if the Workpiece Contact is
pressed against the workpiece prior to pulling the Trigger. It should only actuate again if the Trigger is released
and squeezed again. The Tool should not actuate if the Workpiece Contact is not pressed against an object.
Single-Sequential Actuation Mechanism testing procedure
tO pREVEnt SERiOUS inJURy FROM AcciDEntAL DiScHARGE:
Empty the tool before this procedure. point the tool at a piece of scrap wood when testing.
1. Disconnect the Battery Pack from the tool.
2. Empty the magazine of fasteners.
3. Check that the Trigger and the Workpiece
Contact move freely, without sticking.
4. Connect the Battery Pack to the tool
making sure it clicks in place.
5. Set Activation Switch to the left
(single-sequential actuation).
6. Test the tool by pressing the Workpiece Contact
against the workpiece without pulling the Trigger.
the tool must not cycle (actuate).
If it cycles (actuates), stop immediately and have
it repaired by a qualified service technician.
Item 57180
For technical questions, please call 1-888-866-5797.
2. Secure loose workpieces using a vise or clamps
(not included) to prevent movement while working.
3. There must not be objects, such as utility lines,
nearby that will present a hazard while working.
7. Hold the tool away, or off of the workpiece.
The Workpiece Contact should return to its original
position. Squeeze the Trigger.
the tool must not cycle (actuate).
If it cycles (actuates), stop immediately and
take the tool to a qualified service technician.
8. Press the Workpiece Contact against the workpiece
and squeeze the Trigger.
the tool must cycle (actuate) only once.
Release the Trigger, slide the nailer to a fresh piece
of wood, and squeeze it again.
the tool must cycle (actuate) again only once.
With the Trigger depressed, carefully lift the tool
and press it against the workpiece again.
the tool must not cycle (actuate).
If it fails to act in the manner explained in bold,
have it repaired by a qualified service technician.
Page 9
Hide quick links:
Advertisement
