Morphy Richards Storm 73215 Instruction Booklet page 5

VC73215MUK Rev5_Instruction Booklet 22/09/2011 09:20 Page 5
C
D
Close Open
E
Eco Switch Power setting
For details of other Morphy Richards products, please see our website:
OPERATING THE
APPLIANCE
ASSEMBLY
Suction hose
C
Push the 360° rotating head on
the suction hose into the suction
hose inlet · on the vacuum
cleaner.
To remove, press the hose
connector release button ‚ on
the hose and pull out.
The appropriate cleaning tool
can be attached directly to the
suction hose handle or the
extension tubes can be used
between the suction hose
handle and the tool.
Switching on
Always pull out the supply cable
to its maximum length. Plug the
appliance into the mains supply.
Application
Curtains and
delicate fabrics
Shelves and
hard surfaces
Textiles and
upholstery
Floor coverings,
such as rugs,
economy setting
for carpets
Carpets or hard
floor coverings
Ensure that the Eco Switch ¤ is
set to the required setting before
switching the cleaner on. Push
the Power ON/OFF switch fi to
start the motor.
IMPORTANT: Ensure that the
appliance is never left unattended
whilst it is switched on.
Controlling suction
power
The suction power can be
varied to suit the surface being
cleaned, by using the Eco
Switch ¤, see table (left) for
guideline settings.
The suction power can also be
adjusted using the airflow
control on the handle Ê D.
Closed: full suction
Open: reduced suction
Recommended
settings
Alter the power setting to suit
the surface (as shown in the
table, left).
Switching off
Switch off the appliance.
Remove the plug from the mains
supply and rewind the power
cable using the cable rewind
switch ‹.
WARNING: When using the
cable rewind, always hold the
plug as the cable will rewind
quickly.
STORAGE
Tube park
When finished, you can store
the tubes by locating the tube
storage clip „ into the slot Â
on the base of the cleaner E.
5