Pre-Set The Scooter; Assembly - Hiboy TITAN PRO User Manual

3. Pre-set the scooter

Click "▲" and "▼"button at the same time to enter setting mode. When the number at the bottom of the screen flashes, it
indicates that you have entered the setting mode. Click "▲" and "▼" button to adjust the parameter and click "
enter to next setting mode. After the setting is completed, leave the screen on for about 5 seconds to automatically exit the setting
mode.
Backlight Adjustment
P01
Mileage Unit
P02
Battery Voltage
P03
P04 Sleep Time
Assist Gear
P05
P06 Diameter of the Wheels
Measurement Speed
P07
Speed Limit
P08
P09 Startup Settings
P10 Drive Mode Setting
Resistance Sensitivity Setting
P11
P12 Resistance Start Strength Setting
P13 Assist Magnet Plate Type Setting
Controller Current Limit Setting
P14
Temporarily Unavailable
P15
P16 Clear ODO
Cruise Control
P17
" to confirm and
"1" means darkest, "3" means brightest.
"0" means KM, "1" means MILE.
48V. (DO NOT CHANGE).
0 means no sleep, other numbers are sleep time 1-60 minutes.
0, 3, 5, 9 gears are optional (Not recommend to change)
Keep it "10" inches. (DO NOT CHANGE).
1-100 optional.
Keep it "50"(DO NOT CHANGE)
"0" means Kickstart Mode, "1" means Non-kickstart Mode.
0: assist start; 1: electric drive; 2 assist and electric drive coexist.
Range 1-24
Range 0-5
5, 8, 12 three types of magnet quantity
Range 1-20A
Long press the "▲" for 5 seconds to clear ODO and total time TTM
0: no cruise; 1: cruise.
4

4. Assembly

1. Tighten the folding mechanism
3. Remove 4 screws of the handlebar buckle
2. Install handlebar buckle, tighten the screws
5