Vibration damper
Chip conveyor
Hydraulic top clamps
2M roller table
The vibration damper can be assembled to the left saw arm. This
optional accessory is extremely useful in reducing the high‐
frequency noise produced when cutting large‐sized material.
Chip conveyor is a spiral device to bring chips out during cutting.
As a regular maintenance, remove the chip conveyor and clean all chip
deposits inside.
The top clamp device composed of two clamps is
installed on top of the front and rear vises before
executing bundle cutting.
Refer to Using Top Clamp for Bundle Cutting for
operating procedure on bundle cutting.
The optional 2M roller table supports the work material and
ensures the material be fed in smoothly.
Refer to Section 9 for further information on adjusting the roller
table.
4‐19