Page 2 – cutting status setup
Cut Piece Reset ‐ Reset all Cuts Finished data by
pressing this button for three seconds.
If you start a new set of program without
clearing cutoff data from previous job, the first cut
(trim cut) will be skipped as the second program is
deemed as the succeeding part of the previous
program.
All Reset ‐ Reset all preset cutting data within
Starts JOB and Ends JOB by pressing this button
for three seconds.
Blade Life Reset ‐ Reset the blade life to zero after
installing the new blade.
Current blade life in hours
Error message (bottom of page)
Press Home to return to the main control menu.
Press PGUP to go back to the previous setup page.
Press Next to go to the next setup page.
Page 3 – cutting program setup
In this page you can set your desired cutting length
and quantity and see the number of finished cuts
(Cut Finished).
A total of 100 cutting jobs can be set and
performed under the automatic mode.
In "start job" and the "end job" field, fill in the
number of the cutting job you wish to start and end
with. The machine will automatically perform
cutting jobs within this range.
In Length column, set each respective cutting
length in mm or inch.
In Quantity column, set each respective cutting
quantity.
Press cut reset button for 3 seconds to reset the
cutoff quantity.
If you start a new set of program without clearing
cutoff data from previous job, the first cut (trim cut) will
be skipped as the second program is deemed as the
succeeding part of the previous program.
4‐13